6-mm thick core (group A), (b) extra-thick 1.7 mm occlusal core support (group B), and (c) uniform 1.2-mm thick core (group C). The copings were virtually designed and milled by the CAD/CAM technique. Metal ceramic copings (group D) with the same design as in group C were BGB324 used as controls.
A sample size of N = 20 was used for each group. The copings were veneered with compatible porcelain and fatigue tested under a sinusoidal loading regimen. Loading was done with a 200 N maximum force amplitude under Hertzian axial loading conditions at the center of the crowns using a spherical tungsten carbide indenter. After 100,000 fatigue cycles, the crowns were axially loaded to fracture and maximum load levels before fracture was recorded. One-way ANOVA (P < 0.05) and post selleck chemicals hoc Tukey tests (α = 0.05) were used to determine significant differences between means. The mean fracture failure load of group B was not significantly different from that of control group D. In contrast, the mean failure loads of groups A and C were significantly lower than that of control group D. Failure patterns also indicated distinct differences in failure mode distributions. The results suggest that proper occlusal core support improves veneer chipping fracture resistance in zirconia crowns. Extra-thick occlusal core support for porcelain veneer may significantly reduce the veneer
chipping and fracture of zirconia crowns. This is suggested as an important consideration in the design of copings for zirconia crowns. “
“Skeletal class III malocclusion is one of the most difficult dentofacial anomalies, characterized by deviation in the development of the mandible and maxilla in the sagittal plane, where the mandible is dominant in relation to the maxilla. In patients with class III malocclusion, anomalies in the dentoalveolar level and esthetic discrepancies are also frequent. The etiology of class III malocclusion is multifactorial due to the interaction of hereditary and environmental factors. Rehabilitation and treatment of
malocclusion is one of the major goals of modern dentistry. This article presents the orthodontic-prosthetic therapy and rehabilitation of a 45-year-old patient with an abnormal occlusal BCKDHA vertical dimension and a skeletal class III malocclusion. The patient came to the clinic complaining about degraded esthetics and disordered functions of the orofacial region (functions of eating, swallowing, speech) and also pain in the temporomandibular joint. After the diagnosis was made, the patient was first referred to orthodontic treatment with fixed orthodontic appliances (self-ligating brackets system Rot 0.22). Upon completion of the orthodontic treatment, the patient was sent for further prosthetic treatment. Fixed prosthetic restorations were made in the upper and lower jaw, thus achieving a satisfactory result in terms of esthetics and function of the stomatognathic system.