This suspension

was subsequently dried at 100°C in a dryi

This suspension

was subsequently dried at 100°C in a drying oven and then calcined at 500°C in air for 1 h to prepare the hybrid nanocatalysts. The crystalline structure of the TiO2/MWCNTs nanocatalyst was characterised using X-ray powder diffraction (XRD) (Bruker D8 Advance, Karlsruhe, Germany) equipped with a Cu Kα radiation source operated at 40 kV and 40 mA. The powder morphology was determined by field-emission scanning electron microscopy (FE-SEM; SUPRA 55VP, Carl Zeiss, Jena, Germany) and transmission electron microscopy (TEM; Philips CM12, Amsterdam, The Netherlands; operated at 80 kV) studies. In addition, a Brunauer-Emmett-Teller RGFP966 supplier (BET) (Micromeritics, ASAP 2020, Georgia, USA) was used to determine the surface area of the nanocatalyst. The photocatalytic learn more activity of the TiO2/MWCNTs nanocatalyst was evaluated by monitoring the degradation

of methylene blue (MB) in an aqueous solution under irradiation with ultraviolet (UV) (VL-6.LC lamp) or visible light (VL) (commercial halogen tungsten lamp) using a custom-built setup. A small amount (1 mg) of the sample was suspended in 100 ml of aqueous MB solution with a concentration of 10 ppm. Prior to illumination, the solution was sonicated for 10 min and placed in a dark room for 1 h, thus permitting equilibration of the adsorption–desorption of the dye on the nanocatalyst surface. The first sample (approximately 5 mL) solution was collected immediately and was taken as the initial MB concentration APR-246 chemical structure (c 0). The solution was then Osimertinib continuously shaken at 200 rpm. Approximately 5 mL of the liquid was withdrawn every 20 min and immediately centrifuged to remove any suspended solids. To monitor the degradation of the MB, the clean solution was then analysed using a UV–Visible spectrometer (Perkin Elmer, Lambda 900 UV/Vis) in the range of 500–750 nm. Results and discussion The X-ray diffractogram of the synthesised TiO2/MWCNTs nanocatalysts showed the presence of several crystalline peaks, which are predominantly attributed to anatase TiO2 (Figure 1) [41]. The presence of this phase is due to the significantly high concentration

of TiO2 in the material as well as weak X-ray scattering by MWCNTs. Most of the TiO2 peaks were broad with the calculated crystallite size of approximately 10 nm. The presence of MWCNTs was confirmed by the existence of a peak at a 2θ angle of 42.8°, whereas two other main peaks positioned at 26.1° and 53.6° overlapped substantially with TiO2 peaks. Figure 1 X-ray diffractograms of the TiO 2 /MWCNT hybrids. Figure 2 depicts the FE-SEM images of the TiO2/MWCNTs nanocatalyst. The TiO2 nanoparticles that were produced in situ exhibit a mean particle size of approximately 10 nm. The images illustrate that the TiO2 nanoparticles were well attached to the MWCNTs. In addition, the TiO2/MWCNTs were well dispersed, although a few tangles were observed due to the length of the MWCNTs.

Leave a Reply

Your email address will not be published. Required fields are marked *


You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>